KTM smr 450 2008/2009

Mam ktm450 SXF 07 Repair Manual.pdf jasli to będzie ten sam silnik to podaj email.

To takie same jak hva

Checking the valve clearance ;

– Remove the engine locking screw.
– Switch on the engine several times.
– Move the engine to the ignition TDC position (see Chapter 4) and
insert the engine locking screw.

– Check the valve clearance with feeler gauge 590.29.041.000:

Intake valves: 0.10 - 0.15 mm
Exhaust valves: 0.15 - 0.20 mm

– Write down any deviations from the stipulated valve clearance.
Remove the camshafts and measure the thickness of the mounted
shims. If the measured valve clearance is too small, mount thinner
shims. If the valve clearance is too large, mount thicker shims.
Shims are available in thicknesses of 1.72 to 2.60 mm in 0.04
increments.
– When mounted, check the valve clearance again and correct if
necessary.
– Insert the spark plug and tighten to 10 - 12 Nm.
– Mount both gaskets and the valve cover.
– Insert the valve cover screws together with the rubber seal and
tighten to 8 Nm.

To jest z servisowki z 2007 roku, moze później okazało sie ze jednak mniejszy luz jest lepszy dla tego silnika wiec warto by poszukać manual od sowjego rocznika.

ok dzięki bardzo !